How to use Take Down the Summit Rifle
Before We Begin
- Always make sure the firearm is unloaded before performing any work it!
- Remove all ammunition from the work area before working on any firearms.
- Always wear safety glasses when performing any work on a firearm.
- 5/32" pin punch
- Rubber mallet
- A clean, non-slip surface, such as our Cleaning Mat
Remove the stock from your barreled action.
Use the punch to remove the pins retaining the trigger group and then slide the trigger group out.
Use the punch to remove the recoil buffer from the rear of the stock.
Place the receiver upside down. Pull the bolt handle all the way to the rear to retract the bolt. Carefully roll the receiver over and the bolt will drop out.
At this point, the bolt handle and cam can be rotated out to allow access for cleaning.
Place the receiver upside down. Pivot the cam back inside the receiver and then slide the bolt back into the receiver.
Once you have achieved proper alignment of the cam into the bolt, you'll be able to close the bolt with the bolt handle.
Reinstall the recoil buffer.
Insert the trigger group and insert the pins to retain it.
Perform a function check on the barreled action.
Reinstall the stock.